Classic repairs

  1.  After recording all technical details follows a first tool-control.
  2.  

  3. After that the tool will be taken to pieces. These components will be cleaned in an automatic wash system and if it's necessary we measure and controll them.
  4.  

  5. Wearing parts as ball bearings, rubber ring etc. will be replaced so that a faultless work of the air tool is possible. If there are other components which are defect, we propose a replacement of these components to you.
  6.  

  7. You will get a quotation about these replacements. After your acceptance the complete maintenance of the tool follows. Afterwards it will be tested as specified by the manufacturer.